removing rover 214 inlet manifold

Messages 1 to 2 of 2.

removing rover 214 inlet manifold 31 January 2005, 1:11 PM

sophie69 Joined 31 Jan 2005 2 posts

removing rover 214 inlet manifold 6 February 2005, 7:01 PM

icedfusion Joined 6 Feb 2005 4 posts

I removed the inlet manifold, the inlet manifold is held on by 6 screws and 2 nuts (easily seen). It also has 2 supporting rods, not 1.
with all these off the inlet manifold can be eailsy removed - however, I have limited movement due to all the pipes etc still connected to it.

I have not been able to see a ball-bearing, instead it appears to be a one way valve (which was full of gunk). I am not too sure if the ball bearing is supposed to be on the back side of the inlet manifold or in the hole within the engine (mine is a 1995 model)

Anyway, will be interested to see if you find the ballbearing.

ice.

Messages 1 to 2 of 2.

Important Note

All messages are submitted by visitors to this web site, and represent their own personal opinion. They do not necessarily represent the views or opinions of Preloved.

You use this information at your own risk. Preloved can not be held responsible for any damages or loss resulting from the use of this site. Please see our Terms and Conditions for more details.