406

Messages 1 to 2 of 2.

406 6 July 2008, 9:29 AM

nedcbr600 Joined 1 Oct 2007 18 posts

406 6 July 2008, 6:07 PM

pjl1962 Joined 11 Jun 2007 366 posts

Method for unplugging the battery:

1. Before unplugging the battery, turn off all gadgets and lights, closing all the doors and unplugging any kind of diagnostic tool. The drivers side window has to be kept open for any kind of requirement.
2. Turn off the ignition and take out the key following which unplug the battery after an interval of 3 minutes.
3. The BSI needs to be taken to Sleep mode or Active Economy mode, during which nothing in the vehicle should be operating. Even the bonnet should not be opened that time as it can ?wake up? the BSI if the vehicle has got an alarm installed. For batteries under the bonnet, the bonnet should be opened and left up before allowing the BSI to go to Sleep Mode. During this 3 minute interval, use of any remote control central locking gadgets for other vehicles should be avoided in the vicinity of the concerned vehicle.

Method for starting the BSI:

1. The very first step is to unplug the diagnostic tool from the vehicle.
2. Make sure all the gadgets are switched off, the driver?s window lowered down and open the bonnet.
3. Then close all the doors and take off the key from ignition.
4. After a 3 minute interval, unplug the vehicle?s battery terminals and wait for a further 15 seconds.
5. Attach back the battery terminals and give a 10 second pause making sure the doors are closed.
6. Turn the side lights on.
7. Now turn the engine on and inspect the system functioning.
8. Press and hold down the lock button on the key for 10 seconds.
9. Check the central locking system by unlocking and locking the door consecutively.
10. Turn the engine on again and finish inspecting the system.

Following any other procedure could cause malfunctioning of different units which depend on BSI.

Method for connecting the battery:

The following procedure is for reinstalling the battery connection unless told otherwise by Peugeot or Product service. Failure to follow this procedure may result in damage to the BSI?s embedded software during reconnection.

1. All the doors have to be closed with the ignition key turned off and the key taken out.
2. Now without opening the doors, replug the battery and wait for 10 seconds.
3. Turn on the headlights, turn on the engine and inspect the system?s functioning.

Messages 1 to 2 of 2.

Important Note

All messages are submitted by visitors to this web site, and represent their own personal opinion. They do not necessarily represent the views or opinions of Preloved.

You use this information at your own risk. Preloved can not be held responsible for any damages or loss resulting from the use of this site. Please see our Terms and Conditions for more details.