how 2 bleed clutch on 03 mondeo

Messages 1 to 3 of 3.

how 2 bleed clutch on 03 mondeo 22 June 2009, 11:33 PM

bigted Joined 20 Aug 2007 131 posts

how 2 bleed clutch on 03 mondeo 24 June 2009, 5:26 PM

fasty Joined 27 Jun 2007 1491 posts

1. Remove the air cleaner,
2. Remove the battery,
3. Remove the battery tray,
4. Drain the brake fluid reservoir.

5. Raise and support the vehicle
6. Fill the reservoir of the special tool with approximately 100 ml of new brake fluid.

µ 7. Note:
Make sure that the special tool reservoir is positioned lower than the bleed nipple.

Install the special tool.

8. Using the special tool, bleed the clutch system.

l Pump approximately 80 ml of brake fluid into the clutch system.

9. Close the bleed nipple.

10. Remove the special tool.

11. Lower the vehicle, if necessary.

12. In order to remove any small amounts of trapped air remaining in the system, operate the clutch pedal several times (maximum five times), using the full clutch pedal travel.

13. Check the fluid level in the brake fluid reservoir and top up to the MAX mark with brake fluid if necessary.

14. Install the battery tray, if necessary.

15. Install the battery,
16. Install the air cleaner,
17. Test the clutch control system for normal operation.

l Start the engine, depress the clutch pedal, wait two seconds, then carefully engage reverse gear. If there are any abnormal noises, or reverse gear is difficult to engage, repeat the clutch system bleeding procedure.

18. Initialize the door window motors,

how 2 bleed clutch on 03 mondeo 24 June 2009, 8:00 PM

bigted Joined 20 Aug 2007 131 posts

Messages 1 to 3 of 3.

Important Note

All messages are submitted by visitors to this web site, and represent their own personal opinion. They do not necessarily represent the views or opinions of Preloved.

You use this information at your own risk. Preloved can not be held responsible for any damages or loss resulting from the use of this site. Please see our Terms and Conditions for more details.