caver cascade heater
Messages 1 to 2 of 2.
Discussion Archived
It may just have cobwebs in it, if you feel competent enough you can remove the 4 outer screws & remove the cowling, you then remove the 2 small screws holding on the alloy plate burner cover, you may well be able to see the fault at that point, i.e corroded burner etc. Switch it on & see what its doing. To go any further means you will be breaking a gas joint so you really do need to take care & I'm not recommending you go any further. So you now need to turn off the gas bottle/s, if you look up in the top left corner above the gas solenoid you will find 2 cross head screws if you remove them the gas joint will be broken & you can pull out the burner module, unplug it from the cable in the back of it & if it needs it clean it out, if its a gonner Gary can supply you with a recon unit exchange, or give you more advice on your problem, but you'll have to copy paste your question in his dedicated column, look for all carver cascade questions here etc. Keith ___________________ N.E. Leisure products, registered Powrtouch & Truma distributor, supply & fit at your door the full range of motor movers, used units repaired refurbed & sold, contact me for details at http://www.neleisureproducts.co.uk or [Log in to view email]
Discussion Archived
Messages 1 to 2 of 2.
Important NoteAll messages are submitted by visitors to this web site, and represent their own personal opinion. They do not necessarily represent the views or opinions of Preloved. You use this information at your own risk. Preloved can not be held responsible for any damages or loss resulting from the use of this site. Please see our Terms and Conditions for more details. |
|||||||||
Not a member yet?Why not join the fun for free! Members can sell their stuff completely free of charge, have searches prioritised for their local area, and lots more. Join for free | Member Log In |
|||||||||
|
More discussion in